Height-LED focuses on LED UV retrofits at All in Print China 2026
17.11.2026
Height-LED exhibited at All in Print China 2026, held at SNIEC in Shanghai on October 12–16, 2026. At stand E4B105, the company presented LED and mercury UV curing systems, hybrid units and retrofit kits for existing presses.
A key focus was converting flexographic equipment from mercury UV lamps to LED UV using the HTJP-II-SN series. Designed for web widths from 330–350 mm upwards, these water-cooled modules operate at 395 nm, with other wavelengths available on request. PLC and HMI controls automatically adjust output according to a signal indicating press speed.
A universal curing housing attracted particular attention. It supports both air and water cooling, allowing a mercury lamp to be replaced with an LED-UV unit in any printing station in just a few minutes. Recent retrofit examples include Nilpeter F2400 and Etirama SPS3 presses. In Russia, Vneshmaltigraph, part of VMG-Group and Height-LED’s official representative in the country, completed a similar project on a Gallus EM-280 in Stavropol.
LED systems consume substantially less electricity, require no warm-up or regular lamp replacement, and cause very little heating of the substrate. Mercury systems can become unstable after 7–8 years of operation, while replacement components are increasingly difficult to source. LED retrofits address this issue. Height-LED guarantees spare parts supply and service support, while VMG-Group has five service engineers trained to maintain the manufacturer’s curing systems.
For sheetfed offset presses in formats up to 1050 mm, Height-LED displayed the HTJP-II-SE105025-NH, HTJP-II-SN92040-NH-2 and HTJP-II-SN72040-NH modules. These can be installed in printing units or at the delivery. Upgrading sheetfed equipment remains one of the company’s priorities.
